Check your VIN

Autocar Xpert recalls

13 recall campaigns for the Autocar Xpert, newest first.

  1. Autocar worn parking brake control valve can leak air into the vent line, creating excessive back pressure and causing the parking brake to release unexpectedly. 2008–2012 Autocar WX, WXLL, Xpeditor +2 more 23V-023 · January 23, 2023
  2. Autocar castellated nut on the steer axles may not be properly torqued, allowing the tie rod to loosen. 2016 Autocar Xpert, Xspotter 17V-534 · August 29, 2017
  3. Autocar castle nuts on the steering linkage assembly may not have been tightened properly. 2015 Autocar Xpert, Xspotter 16V-723 · October 7, 2016
  4. Autocar tab lock washers on the rear axle wheel ends may not have been properly bent over the outer spindle nut during assembly. 2016–2017 Autocar Xpert, Xspotter 16V-319 · May 18, 2016
  5. Autocar excessive engine crankcase pressures may cause the 90-degree elbow of the vent tube assembly to detach from the crankcase ventilation breather, possibly allowing engine oil to come into contact with hot surfaces. 2014 Autocar Xpert, Xspotter 15V-281 · May 13, 2015
  6. Autocar when being driven at speeds above 25mph, the affected vehicles may have an unexpected bounce. 2012 Autocar Xpert 14V-397 · July 2, 2014
  7. Autocar during manufacturing, the floor mat may have been captured between the seat brackets and the cab sheet metal at all four connection points. 2012 Autocar Xpert 14V-198 · April 23, 2014
  8. Autocar bolts securing the brake valve to the cab may be below the required torque which could cause a failure in the connection of the airlines and the brake valve. 2012 Autocar Xpert 14V-199 · April 23, 2014
  9. Autocar bolts that secure the steering column mounting bracket could be below the required torque and possibly cause the steering column to come loose. 2012 Autocar Xpert 14V-200 · April 23, 2014
  10. Autocar condensation in the intake manifold may freeze during cold weather conditions and interfere with the proper operation of the intake manifold pressure sensor. 2014 Autocar Xpert 14V-130 · March 19, 2014
  11. Autocar bolts used to anchor the seat belts may be insufficiently tight to withstand the forces experienced in certain crashes. 2012 Autocar Xpert 14V-133 · March 19, 2014
  12. Autocar seat belt anchorages fail to sustain the 3000 pound forces for the specified length of time. 2012 Autocar Xpert 13V-006 · January 9, 2013
  13. Autocar negative cable ground stud and/or wiring harness on each vehicle may interfere with the right-hand drivers side brake pedal. 2012 Autocar Xpert 12V-448 · September 13, 2012