Ferrara Igniter recalls
- Ferrara steering gears may have been assembled incorrectly, which can cause the gears to fracture. 2021 Ferrara Cinder, Igniter, Inferno
- Ferrara additional resistor was incorrectly installed on the printed circuit board, which can disrupt CAN network communication and cause vehicle lighting to fail. 2021 Ferrara Igniter, Inferno
- Ferrara fuel tubes between the fuel rail and the injectors for cylinders four, five, and six may fatigue and crack, which can result in a high pressure fuel leak. 2019 Ferrara Cinder, Igniter, Inferno
- Ferrara ferrara Fire Apparatus, Inc. 2020 Ferrara Igniter
- Ferrara sealing washer may not seat correctly in the pilot bore holes, allowing the high pressure fuel rail assembly to leak. 2017 Ferrara Igniter, Inferno
- Ferrara depending on the specific wiring of the vehicle, these brake lights may illuminate when the brake pedal has not been pressed. 2017 Ferrara Cinder, Igniter, Inferno +2 more
- Ferrara inconsistent machining may result in fatigue cracks developing over time in the front axle spindles, causing failure of the spindle and the possible separation of a front wheel from the vehicle. 2004 Ferrara Igniter, Inferno
- Ferrara rings securing the valves may corrode over time after exposure to water, causing the ring to fail and the pressure relief valve to open, reducing the water pressure available for fire fighting. 2013–2015 Ferrara Cinder, Ember, Igniter +4 more
- Ferrara affected vehicles may be equipped with certain C20 and C21 split-shaft transmissions from Waterous. 2015 Ferrara Cinder, Igniter, Inferno +1 more
- Ferrara these touchscreens may experience false switch activations that can happen without the operator's knowledge causing accessories to turn on or off, affecting vehicle performance. 2011 Ferrara Cinder, Igniter, Inferno +1 more
- Ferrara affected power control modules may not provide sufficient circuit protection depending on their combination of software and installation, possibly resulting in a short circuit. 2014 Ferrara Igniter
- Ferrara these pumps have 6" intake strainers that may have been improperly soldered during production and, as a result, the strainers may come apart during use, allowing parts of the strainer and debris to enter the pump, possibly damaging the pump. 2015 Ferrara Cinder, Igniter, Inferno +2 more
- Ferrara affected vehicles are built with independent front suspensions that may have loose ball joints. 2013 Ferrara Igniter, Inferno
- Ferrara are equipped with Meritor axle assemblies that were built with disc brakes using MGM J24 series air brake chambers. 2011 Ferrara Igniter, Ultra
- Ferrara ESC module may cause the ESC system to activate unnecessarily when the vehicle is driven in a particular manner on certain unique road conditions and may adversely affect the slip angle calculation by the ESC module. 2009 Ferrara Igniter, Inferno
- Ferrara rubber diaphragm inside the qrv may experience delamination resulting in significant levels of air pressure leakage past AND/OR through the diaphragm, or the development of a bubble in the diaphragm which may trap air pressure in the valve and not allow the service brakes to release. 2008 Ferrara Igniter, Inferno