Models

• TZ-34 7
• TZ-50 7

1. Genie bolts that connect the slew turntable bearing to the chassis may have been under tightened. 2020 Genie TZ-34, TZ-50 20V-637 · October 15, 2020
2. Genie bolted joints of the tongue structure may loosen and possibly separate from the main chassis. 2020 Genie TZ-50 20V-552 · September 10, 2020
3. Genie battery cable ends at the quick disconnect may have been improperly crimped, resulting in possible excessive heat build-up of the conductor. 2019 Genie TZ-34, TZ-50 19V-253 · March 28, 2019
4. Genie affected lifts have bolts that attach the turntable to the rotation bearing that may not have been properly tightened. 2016 Genie TZ-34/20 16V-067 · February 5, 2016
5. Genie due to out of specification cylinders, the stabilizing outriggers may drift while the boom lift is being used. 2015 Genie TZ-34/20 15V-326 · May 29, 2015
6. Genie in the affected trailers, the outrigger assembly may not remain stowed upright while the trailer is being transported. 2003 Genie TZ-34 13V-420 · September 12, 2013
7. Genie this component was also installed as a service part replacement on tmz 34/19 and tmz 50 units as part number 96769 and kit 99854 from january 1, 2010, through august 7, 2011. 2010 Genie Motor Controller, TZ-34, TZ-50 12V-022 · January 26, 2012
8. Genie this component is also installed as a service part replacement on tmz 34/19 and tmz 50 as part number 96769 and kit 99854 from april 13, 2011, through july 13, 2011. 2011 Genie Motor Controller, TZ-34, TZ-50 11V-373 · July 21, 2011
9. Genie materials used in the boom and chassis components are susceptible to cracking. 2010 Genie TZ-50 10V-619 · December 9, 2010
10. Genie material used in the platform support components was not in compliance the MANUFACTURER'S specifications. 2009 Genie TZ-34, TZ-50 10V-286 · June 22, 2010
11. Genie on certain trailer mounted aerial work platform booms, the turntable bearing bolts may not be tightened to specifications. 2007 Genie TZ-34 07V-558 · December 12, 2007