Altec recalls — Page 2
- Altec collision mitigation system software may not be calibrated correctly, prohibiting the active braking system from activating. 2020 Altec Aerial Device
- Altec water can leak into the strobe lights, which could cause an electrical short-circuit. 2021 Altec Aerial Device, Digger Derrick, Effer Crane +1 more
- Altec boom pressure limiter may allow the boom to lift loads above the rated capacity and over the Hydraulic Overload Protection (HOP) setting. 2021 Altec Digger Derrick
- Altec hardware that secures the removable auger hex extension bar to the drive unit coupler was not installed, which may cause it to detach. 2017 Altec Digger Derrick
- Altec base of the rear pole rack may be missing a weld. 2016 Altec Aerial Device, Digger Derrick
- Altec during production, an incorrect bolt may have been used to attach the derrick rotation bearing. 2022 Altec Digger Derrick
- Altec material handling interlocking valve may lose power when the outriggers are not set, allowing the jib winch to be operated while the outriggers are up. 2019 Altec Aerial Device
- Altec weld between the base boom and the auger stow bracket could crack. 2015 Altec Aerial Device
- Altec wire to the boom stow sensor may be routed over a sharp edge, which can expose the wire to metal and result in a blown ignition circuit fuse. 2017 Altec Aerial Device
- Altec ground-fault circuit interrupter (gfci) outlet may not provide adequate circuit protection against an electrical overload condition. 2016 Altec AT200A, AT30-G
- Altec relay connectors may have been reattached to the incorrect plug after a stability test was performed. 2016 Altec Digger Derrick
- Altec vehicles are not equipped with carbon monoxide detectors. 2017 Altec Aerial Device
- Altec chassis fuel line clamps may not have been secured properly after they were removed to install an aftermarket accessory. 2016 Altec Aerial Device
- Altec unit subbase may develop cracks in the bulkhead plate, which can cause the shear plates to fail. 2018 Altec Aerial Device, Digger Derrick
- Altec bolts in the rotation bearing outer-race may have been over-tightened, allowing the bolts to break. 2019 Altec Aerial Device
- Altec outer-race rotation bearing bolt washers may interfere with an adjacent pedestal weld, which could cause the rotation bearing bolts to break. 2017 Altec Aerial Device
- Altec when operating the boom positioning control lever, a defective linear potentiometer may cause the boom to move in an unintended direction. 2021 Altec Aerial Device
- Altec hydraulic plumbing to the lift cylinders of the lower and upper booms could be connected incorrectly, allowing the boom to overextend. 2017 Altec Aerial Device
- Altec cracks may develop in the legs of the mounting frame, which can cause the mounting frame side plate to break. 2012 Altec Aerial Device
- Altec cracks may develop in the legs of the mounting frame, which can cause the mounting frame side plate to break. 2011 Altec Aerial Device
- Altec outer-race rotation bearing bolt washers may interfere with an adjacent pedestal weld, which could cause the rotation bearing bolts to break. 2016 Altec Aerial Device
- Altec cylinder rod threads may not have been machined properly, which could result in uncontrollable boom movement. 2021 Altec Aerial Device
- Altec operator may inadvertently move the pole guide joystick with their forearm due to the close proximity between the controls. 2016 Altec Digger Derrick
- Altec leveling sprocket may have a failed weld between the sprocket and hub assembly. 2020 Altec Aa-Class, An-Class
- Altec retaining ring in the gearbox assembly was improperly seated during production, allowing the boom to unintentionally rotate freely. 2020 Altec D2000, D3000, D4000
- Altec bolts of insufficient strength may have been used to connect the pedestal and sub-base, which could cause the bolts to become overloaded. 2020 Altec Aerial Device
- Altec lower and upper boom raise spools can shift after releasing the joystick or control interlock. 2005 Altec Aerial Device
- Altec chains used to tie down the TDA-58 for transport may break. 2014 Altec TDA58
- Altec rotation bearing fasteners may experience stress corrosion cracking. 2017 Altec Aerial Device
- Altec flexible section of the exhaust pipe may separate, creating an exhaust gas leak. 2017 Altec DC1317 Chipper, DRM12 Wood Chipper
- Altec location of the capacity placard plate could cause a pinch point between the boom and the placard plate. 2017 Altec DT65-E, DT65-H
- Altec these units only have the derrick use capacity chart and do not have the combined use capacity chart. 2016 Altec Aerial Device
- Altec boom valve has a shuttle cartridge installed instead of a plug. 2020 Altec Aerial Device
- Altec hydraulic check valve can have a snap ring failure resulting in the snap ring becoming lodged in a counterbalance or control valve allowing continued movement. 2018 Altec Aerial Device, Digger Derrick
- Altec incorrect counterbalance valve may have been installed in the main lift cylinder. 2006 Altec AH125, AH150
- Altec bolts that secure the pedestal to the turntable (with head marking 5252) may fail. 2019 Altec Aerial Device, Digger Derrick
- Altec load holding grip of the grapple tines may loosen, resulting in a loss of load control. 2018 Altec EC505, EC655
- Altec during an HC Desorb cycle, the vehicle's idle will rapidly rise causing an increase in pump flow. 2015 Altec Aerial Device
- Altec boom lift hydraulic cylinder end gland may fail causing uncontrolled boom movement. 1995 Altec Aerial Device
- Altec PTO may leak oil onto the exhaust heat shield thermal blanket. 2017 Altec Aerial Device
- Altec tow hitch may have incorrect load rating markings, and may have been damaged by unintentional overloading. 2014 Altec Aerial Device
- Altec bolts that secure the pedestal to the turntable (with head marking 5185) may fail. 2018 Altec Aerial Device, Digger Derrick
- Altec battery fuse holder may have been improperly mounted, potentially causing an electrical short circuit. 2017 Altec ST Spray Truck
- Altec rear tire size and load rating may be incorrect, possibly resulting in the vehicle being overloaded. 2016 Altec AT200A
- Altec operators could inadvertently open the pole guide while performing other tasks, possibly resulting in a loss of control of the load. 2019 Altec Digger Derrick
- Altec high strength fasteners used to secure the pedestal to the turntable may fail. 2019 Altec L42M, LR756, LR758 +3 more
- Altec boom lift cylinder hose may have been connected to a port that does not have an internal velocity fuse. 2015 Altec Crane
- Altec aerial devices have not been stability tested in accordance with ansi a92.2. 2018 Altec Aerial Device
- Altec outrigger valves may be plumbed incorrectly. 2016 Altec Digger Derrick
- Altec trailer brake controller may be improperly grounded. 2019 Altec Aerial Device