E-One Cyclone Ii recalls
- E-One positive power supply may be loose, causing the wiring harness and busbar to overheat. 2024–2026 E-One Cyclone Ii, Cyclone N, Typhoon N
- E-One hydraulic valve may become inoperative, preventing the outriggers from being extended or retracted. 2025–2026 E-One Cyclone Ii, Cyclone N, Typhoon N
- E-One engine crossmember may break, allowing the cooling fan to contact the fan shroud and become damaged. 2020–2021 E-One Cyclone Ii, Cyclone N, Quest Ii +1 more
- E-One engine crossmember may break, allowing the cooling fan to contact the fan shroud and become damaged. 2022 E-One Cyclone Ii, Cyclone N, Typhoon N
- E-One steering assist bracket may have been machined incorrectly. 2022–2023 E-One Cyclone E, Cyclone Ii, Cyclone N +1 more
- E-One in the event of a short circuit or wiring failure, the firmware in the vehicle multiplex system may fail to shut off the output pin, resulting in overloaded electrical circuits. 2020–2023 E-One Arff, Commercial, Cyclone E +4 more
- E-One transmission cooler may be insufficiently welded, which can result in engine coolant contaminating the transmission fluid. 2022 E-One Cyclone Ii, Cyclone N, Typhoon N
- E-One exhaust heat may build up inside the vehicle body in certain situations such as heavy engine use, possibly causing nearby components to overheat. 2019–2020 E-One Cyclone Ii, Typhoon N
- E-One tie rod clamps may have been improperly heat-treated, causing them to crack and allowing the tie rods to separate. 2022 E-One Cyclone Ii, Cyclone N, Typhoon N
- E-One neutral screw connection within the QO Plug-On Neutral Load Center may be loose. 2019–2021 E-One Commercial, Cyclone Ii, Cyclone N +3 more
- E-One additional resistor was incorrectly installed on the printed circuit board, which can disrupt CAN network communication and cause vehicle lighting to fail. 2022 E-One Commercial, Cyclone Ii, Cyclone N +1 more
- E-One fuel tubes between the fuel rail and the injectors for cylinders four, five, and six may fatigue and crack, which can result in a high pressure fuel leak. 2019–2021 E-One Cyclone Ii, Cyclone N, Quest Ii +2 more
- E-One rear axle drive pinion may fracture. 2021 E-One Cyclone Ii, Cyclone N, Typhoon +1 more
- E-One sealing washer may not seat correctly in the pilot bore holes, allowing the high pressure fuel rail assembly to leak. 2017 E-One Cyclone Ii, Cyclone N, Quest Ii +2 more
- E-One steering gear mounting bolts may become loose and back out, resulting in difficulty steering. 2020 E-One Cyclone Ii, Typhoon, Typhoon N
- E-One these displays may experience low voltage spikes, causing the LCD display to lock up or become nonfunctional. 2019–2020 E-One Commercial, Cyclone Ii, Cyclone N +3 more
- E-One lower shock mount bracket may cause the U-bolts to bind and break, possibly preventing the rear axle from remaining secured. 2018 E-One Cyclone Ii, Typhoon
- E-One engines do not have a diode in the starter solenoid circuit to improve the longevity of the lock-out relay, resulting in accumulated damage over time. 2013–2017 E-One CHSH, Cyclone Ii, Cyclone Iii +2 more
- E-One front shocks may separate from their upper mount on the front suspension. 2013–2015 E-One Cyclone Ii, Quest, Typhoon
- E-One due to improper manufacturing, the cushion of the Inflatable Head Cushion (IHC) and Knee Air Bag (KAB) may detach during a deployment event and not inflate. 2019 E-One Cyclone Ii, Typhoon
- E-One high current load in the hvac system can cause one of the relays to melt. 2012 E-One Cyclone Ii, Cyclone Iii, Typhoon
- E-One torque rod tower may crack causing failure of the tower, possibly affecting vehicle handling. 2016 E-One Cyclone Ii, Typhoon
- E-One depending on the specific wiring of the vehicle, these brake lights may illuminate when the brake pedal has not been pressed. 2017 E-One Cyclone Ii, Quest Ii, Typhoon
- E-One over time, movement of the bucket on the aerial ladder may cause stress fractures in the ladder tubing, compromising the integrity of the aerial device. 2016 E-One Cyclone Ii
- E-One inconsistent machining may result in fatigue cracks developing over time in the front axle spindles, causing failure of the spindle and the possible separation of a front wheel from the vehicle. 2008 E-One Cyclone Ii, Quest Ii, Typhoon
- E-One affected engines do not have a diode in the starter solenoid circuit to improve the longevity of the lock-out relay, resulting in accumulated damage over time. 2013 E-One Cyclone Ii, Quest Ii, Typhoon
- E-One electrical connections at the transfer switch may loosen and cause excessive heat. 2005 E-One Cyclone Ii, Cyclone Iii, F550 +7 more
- E-One rings securing the valves may corrode over time after exposure to water, causing the ring to fail and the pressure relief valve to open, reducing the water pressure available for fire fighting. 2013–2016 E-One Cyclone Ii, Quest, Typhoon +5 more
- E-One power steering assist cylinder may not have been properly tightened to the steering arm. 2016 E-One Cyclone Ii, Quest, Typhoon
- E-One castellated nut on the steer axles may not be properly torqued, allowing the tie rod to loosen. 2015 E-One Cyclone Ii, Quest Ii
- E-One ball joints on the independent front suspension (IFS) modules can loosen and separate, leading to a partial loss of steering. 2013–2014 E-One Cyclone Ii, Quest, Typhoon
- E-One affected vehicles may be equipped with certain C20 and C21 split-shaft transmissions from Waterous. 2015 E-One Cyclone Ii, Typhoon
- E-One affected power control modules may not provide sufficient circuit protection depending on their combination of software and installation, possibly resulting in a short circuit. 2014 E-One Cyclone Ii, Typhoon
- E-One these pumps have 6" intake strainers that may have been improperly soldered during production and, as a result, the strainers may come apart during use, allowing parts of the strainer and debris to enter the pump, possibly damaging the pump. 2015 E-One Cyclone Ii, Quest Ii, Typhoon
- E-One affected vehicles may have left the production facility with a harness for the front air bag system disconnected. 2014 E-One Cyclone Ii, Quest, Typhoon
- E-One affected vehicles have front independent suspension assemblies that may have loose ball joints which could separate causing a loss of steering control. 2013 E-One Cyclone Ii, Quest, Typhoon
- E-One VIM, used to supply programming inputs that monitor and control some vehicle functions such as lights, warning indicators and some interlock functions of the vehicle electrical system, has software that may experience a defect that affects the operation of the brake lights and other electrical operations of the vehicle. 2013 E-One Cyclone Ii, Quest, Typhoon
- E-One when the button is pressed to release the seat belt, the latch plate can become partially engaged with the buckle, making the seat belt difficult to unlatch. 2013 E-One Cyclone Ii, Quest, Typhoon
- E-One are equipped with Meritor axle assemblies that were built with piston air parking brake actuators. 2011 E-One Cyclone Ii
- E-One under certain road and driving conditions, vehicle body roll and road inclination characteristics may adversely affect the slip angle calculation of the electronic stability control (ESC) system. 2008 E-One Cyclone Ii, Quest, Typhoon
- E-One V-BAND clamp assembly, part numbers Q187684, Q187685, and Q187686, used to connect the inlet and outlet cone sections to the diesel oxidation catalyst (DOC)/DIESEL particulate filter (dpf) include a T-BOLT which can fracture and fail when subjected to stress or load. 2010–2011 E-One Cyclone Ii, Quest, Tradition +1 more
- E-One if the mounting fasteners are not at proper torque value, the outside door handle mount bracket may potentially rotate out of position. 2010 E-One Cyclone Ii, Tradition, Typhoon
- E-One there is a software problem in the engine control computer that may cause unexpected engine shut down under certain operating conditions. 2008 E-One Cyclone Ii, Quest