Kenworth T2000 recalls
- Kenworth degradation of a combustion tube weld can cause radial heat impingement on the body which may burn through certain bodies used on C15 engines. 2007–2009 Kenworth C500, T2000, T600 +3 more
- Kenworth oil module centrifugal spinner filter cap in the paccar mx engine may become loose, possibly allowing the cap to come off and engine oil to partially discharge from the oil module onto exhaust components. 2007–2012 Kenworth T2000, T660, T700 +12 more
- Kenworth bearing surfaces of the extended lube universal joint that attaches the INTER-AXLE driveline to the drive axle may become prematurely worn due to breakdown of lubrication AND/OR excessive heat. 2007 Kenworth T2000, T600, T660 +10 more
- Kenworth circumferential weld around the steering shaft tube that welds the splined tube to the NON-SPLINED tube may be mislocated. 2008 Kenworth C500, T2000, T660 +9 more
- Kenworth rear axle outer end hub may have not been primed with oil properly during the rear axle installation process. 2010 Kenworth T2000, T660, T800 +1 more
- Kenworth mislocation of a circumferential weld may allow the splined tube and NON-SPLINED tube to rotate relative to one another during a low speed, high torque turn, possibly resulting in a separation of the two tubes. 2009 Kenworth T2000, T660, T800 +8 more
- Kenworth certain trucks equipped with eaton synflex eclipse brand extruded nylon air brake hose tubing fail to comply with the requirements of federal motor vehicle safety standard no. 2008 Kenworth C500, T2000, T600 +13 more
- Kenworth certain door latch assemblies on these vehicles fail to conform to the requirements of federal motor vehicle safety standard no. 2008–2009 Kenworth C500, T2000, T660 +10 more
- Kenworth certain trucks fail to comply with the brake timing regulatory requirements of federal motor vehicle safety standard no. 2007 Kenworth C500, T2000, T800 +1 more