Check your VIN

Pierce Manufacturing Saber recalls

22 recall campaigns for the Pierce Manufacturing Saber, newest first.

  1. Pierce Manufacturing steering linkage arm bolt may come loose, resulting in the steering linkage arm detaching from the steering motor. 2025 Pierce Manufacturing Arrow XT, Enforcer, Impel +2 more 26V-060 · February 2, 2026
  2. Pierce Manufacturing bumper may partially obstruct the rear lights. 2020–2023 Pierce Manufacturing Enforcer, Saber, Velocity 24V-127 · February 21, 2024
  3. Pierce Manufacturing tie rod clamps may have been improperly heat-treated, causing them to crack and allowing the tie rods to separate. 2022 Pierce Manufacturing Arrow XT, Enforcer, Saber 22V-892 · December 2, 2022
  4. Pierce Manufacturing sealing washer may not seat correctly in the pilot bore holes, allowing the high pressure fuel rail assembly to leak. 2017 Pierce Manufacturing Arrow XT, Enforcer, Impel +3 more 21V-394 · May 26, 2021
  5. Pierce rear LED lights may be too bright. 2016 Pierce Freightliner, Enforcer, Saber 21V-222 · March 30, 2021
  6. Pierce depending on the specific wiring of the vehicle, these brake lights may illuminate when the brake pedal has not been pressed. 2017 Pierce Commercial, Arrow XT, Dash +5 more 18V-756 · October 26, 2018
  7. Pierce rings securing the valves may corrode over time after exposure to water, causing the ring to fail and the pressure relief valve to open, reducing the water pressure available for fire fighting. 2015 Pierce Commercial, Arrow XT, Enforcer +3 more 18V-050 · January 11, 2018
  8. Pierce Manufacturing castellated nut on the steer axles may not be properly torqued, allowing the tie rod to loosen. 2015 Pierce Manufacturing Arrow XT, Enforcer, Impel +3 more 17V-570 · September 14, 2017
  9. Pierce Manufacturing affected vehicles may be equipped with certain C20 and C21 split-shaft transmissions from Waterous. 2015 Pierce Manufacturing Arrow XT, Dash, Enforcer +4 more 16V-585 · August 5, 2016
  10. Pierce Manufacturing these pumps have 6" intake strainers that may have been improperly soldered during production and, as a result, the strainers may come apart during use, allowing parts of the strainer and debris to enter the pump, possibly damaging the pump. 2015 Pierce Manufacturing Arrow XT, Enforcer, Impel +3 more 16V-390 · June 1, 2016
  11. Pierce Manufacturing clamps on the heater hose may have been improperly installed allowing engine coolant to leak into the passenger compartment. 2014 Pierce Manufacturing Enforcer, Saber 16V-148 · March 10, 2016
  12. Pierce Manufacturing fastener cap over the bearing on the universal joint of the drive shaft may have been improperly tightened. 2016 Pierce Manufacturing Arrow XT, Dash, Enforcer +4 more 16V-123 · March 2, 2016
  13. Pierce Manufacturing affected vehicles have fire hose water pressure regulators that may not respond consistently to operator input and, as a result, there may be an unexpected water pressure surge to the fire hose. 2013 Pierce Manufacturing Arrow XT, Impel, Quantum +2 more 15V-760 · November 16, 2015
  14. Pierce Manufacturing affected vehicles are equipped with front drive axles whose hex nuts on the flange yoke may not have been properly tightened. 2015 Pierce Manufacturing Arrow XT, Enforcer, Saber +1 more 15V-706 · October 26, 2015
  15. Pierce Manufacturing rear axle cast iron leaf spring spacer block may crack and fracture. 2015 Pierce Manufacturing Enforcer, Impel, Saber +1 more 15V-174 · March 25, 2015 DO NOT DRIVE
  16. Pierce pierce Manufacturing Inc. 2009 Pierce Commercial, Arrow XT, Enforcer +4 more 13V-518 · October 22, 2013
  17. Pierce Manufacturing these compartments extend inboard horizontally from the side of the rear body. 2005–2011 Pierce Manufacturing Arrow XT, Custom Contender, Dash +5 more 11V-551 · November 10, 2011
  18. Pierce Manufacturing under certain road and driving conditions, vehicle body roll and road inclination characteristics may adversely affect the slip angle calculation of the electronic stability control (ESC) system. 2007–2009 Pierce Manufacturing Arrow XT, Custom Contender, Impel +3 more 11V-527 · November 1, 2011
  19. Pierce Manufacturing V-BAND clamp assembly, part numbers Q187684, Q187685, and Q187686, used to connect the inlet and outlet cone sections to the diesel oxidation catalyst (DOC)/DIESEL particulate filter (dpf) include a T-BOLT which can fracture and fail when subjected to stress or load. 2011 Pierce Manufacturing Arrow XT, Custom Contender, Dash +3 more 11V-422 · August 17, 2011
  20. Pierce are equipped with fuel tank straps that may corrode due to winter road salt or liquid DE-ICING chemicals. 1995–2003 Pierce Arrow, Commercial, Arrow XT +6 more 11V-384 · July 26, 2011
  21. Pierce Manufacturing battery switch positive electrical post may come in contact with the driver seat base reinforcement. 2010 Pierce Manufacturing Custom Contender, Saber 10V-425 · September 21, 2010
  22. Pierce Manufacturing these trucks may be equipped with DROP-DOWN fire hose trays mounted under the front bumper. 2003 Pierce Manufacturing Custom Contender, Dash, Enforcer +4 more 10V-300 · June 28, 2010