Check your VIN

Utility recalls

13 recall campaigns for Utility, newest first.

Models

  1. Utility incorrect tape was installed on the top foil, which could result in the sealer plate separating from the roof. 2022 Utility Utility Trailer 21V-676 · August 31, 2021
  2. Utility weld that secures the mud flap bracket to the suspension beam may allow the mud flap bracket to detach. 2017 Utility VS2RA 17V-483 · August 1, 2017
  3. Utility in the affected trailers, the rear aerodynamic device (RAD) may separate from the rear of the tarping system, due to rivet failure. 2015 Utility Flatbed Trailers 16V-674 · September 19, 2016
  4. Utility these valves may have been improperly machined which may cause a delay of application of the spring brakes while parking. 2014 Utility DRY Van Trailers, Flatbed Trailers, Refrigerated Trailers 16V-503 · July 5, 2016
  5. Utility affected axle assemblies have caliper bolts that may not have been properly tightened, allowing the caliper mounting bolts to back out and the caliper to detach from the axle flange. 2015 Utility VS2RA 15V-774 · November 19, 2015
  6. Utility affected actuators may have an incomplete attachment of the internal rubber diaphragm to the actuation mechanism of the parking brake section of the Life Seal actuator. 2014 Utility FS2CHA, VS1DC, VS1RA +2 more 15V-063 · February 4, 2015
  7. Utility pintle hook tube sub assembly that is welded to the pintle hook safety chain loop may break and fall off the vehicle. 2012–2014 Utility VS1DC, VS1RA, VS2DX +3 more 14V-463 · July 30, 2014
  8. Utility affected trailers may have over-tightened axle nuts which may result in axle bearing failure. 2015 Utility VS1RA, VS2RA, VS3RA 14V-221 · April 24, 2014
  9. Utility brake system check valve was installed incorrectly, causing a delay in brake application. 2013 Utility VS2DX 12V-298 · June 26, 2012
  10. Utility mounting plates used for mounting single or double battery boxes on trailers may be the incorrect size and some may also have been misoriented during installation. 2011 Utility VS1DC, VS2DX 12V-020 · January 20, 2012
  11. Utility due to an incomplete "knitting" of the iron at the time of casting, inadequate structural integrity of the slack adjuster housing can occur, which could cause the housing to break at the handle under normal operating loads. 2011 Utility VS2RA 11V-191 · March 24, 2011
  12. Utility insufficient torque may have been applied on the spindle nut on the arvinmeritor tl series trailer axles installed in these van trailers where the stake washer for the nut is staked in a single location as opposed to multiple locations. 2007–2008 Utility VS2RA, VS2DX 11V-117 · February 18, 2011
  13. Utility suspect systems may have missing welds at the interface of the lower seat bracket and axle beam. 2009 Utility VS2RA 10V-545 · November 5, 2010