Utility VS2RA recalls
- Utility weld that secures the mud flap bracket to the suspension beam may allow the mud flap bracket to detach. 2017 Utility VS2RA
- Utility affected axle assemblies have caliper bolts that may not have been properly tightened, allowing the caliper mounting bolts to back out and the caliper to detach from the axle flange. 2015 Utility VS2RA
- Utility affected actuators may have an incomplete attachment of the internal rubber diaphragm to the actuation mechanism of the parking brake section of the Life Seal actuator. 2014 Utility FS2CHA, VS1DC, VS1RA +2 more
- Utility pintle hook tube sub assembly that is welded to the pintle hook safety chain loop may break and fall off the vehicle. 2012–2014 Utility VS1DC, VS1RA, VS2DX +3 more
- Utility affected trailers may have over-tightened axle nuts which may result in axle bearing failure. 2015 Utility VS1RA, VS2RA, VS3RA
- Utility due to an incomplete "knitting" of the iron at the time of casting, inadequate structural integrity of the slack adjuster housing can occur, which could cause the housing to break at the handle under normal operating loads. 2011 Utility VS2RA
- Utility insufficient torque may have been applied on the spindle nut on the arvinmeritor tl series trailer axles installed in these van trailers where the stake washer for the nut is staked in a single location as opposed to multiple locations. 2007–2008 Utility VS2RA, VS2DX
- Utility suspect systems may have missing welds at the interface of the lower seat bracket and axle beam. 2009 Utility VS2RA