Volvo VNL recalls — Page 2
- Volvo are equipped with an MGM Type 24 J-series piston parking brake chamber. 2011 Volvo VHD, VNL
- Volvo remote battery disconnect switch was manufactured with incorrect hardware allowing the cables to loosen. 2012 Volvo VHD, VNL, VNM
- Volvo in extremely cold conditions, these bendix relay valves may potentially develop internal leakage. 2011 Volvo VHD, VNL, VNM
- Volvo during the coupling process, it is possible for the driver to partially close the fifth wheel lock and if solely relying on a tug test (pull test), the driver may think that the fifth wheel lock is properly coupled to the trailer king pin when in fact it is not properly coupled. 2011 Volvo VNL, VNM
- Volvo tubing used to assemble the drivelines has a nonconforming seam weld with insufficient bonding of the material. 2012 Volvo VHD, VNL, VNM
- Volvo due to an incomplete "knitting" of the iron at the time of casting, inadequate structural integrity of the slack adjuster housing can occur, which could cause the housing to break at the handle under normal operating loads. 2011–2012 Volvo VHD, VNL, VNM
- Volvo there is a potential for the vehicle to start without warning because of an unintended path to ground that exists. 2011 Volvo VNL
- Volvo official notice describes a safety defect, but the details were not provided in plain language. 2008 Volvo VHD, VNL, VNM +1 more
- Volvo bottom track that attaches to the arms used to open and close the window may DE-BOND, which results in the glass coming loose at the bottom. 2009 Volvo VN, VNL, VT
- Volvo certain factors can exist, which if left untreated may result in a ball socket separation. 2001 Volvo VNL, VNM
- Volvo adhesive used in the upper window in the bunk area to secure the glass may debond. 2010 Volvo VNL
- Volvo on certain trucks, the hood restraint cylinder does not contain enough dampening to adequately restrain the hood. 2008 Volvo VHD, VNL, VNM +1 more
- Volvo on certain trucks, an unprotected lead in the thermoswitch of the heater may make contact with another post possibly creating a short circuit, which can result in continuous operation of the heating element. 2007 Volvo VHD, VNL, VNM +1 more
- Volvo on certain trucks equipped with arvinmeritor rpl20 high angle interaxle driveshafts, an improper seated or missing snap ring can result in the bearing cup to separate from the slip yoke SUB-ASSEMBLY. 2007 Volvo VNL, VNM, VT
- Volvo certain trucks equipped with front steer axle air suspension may develop a front wheel wobble when the tires become worn. 2003 Volvo VNL, VNM
- Volvo certain heavy duty trucks fail to comply with the requirements of federal motor vehicle safety standard no. 2004 Volvo VNL, VNM
- Volvo on certain HEAVY-DUTY trucks, when the bunk is raised into the stored position, an object left on the bunk may inadvertently turn on a bunk lamp. 2002 Volvo VNL
- Volvo on certain heavy duty class 8 trucks, the sleeper section upper side window glass may DE-BOND from the window opening slide track mechanism. 2003 Volvo VNL
- Volvo certain heavy duty class 8 vehicles fail to comply with federal motor vehicle safety standard no. 2001 Volvo VNL, VNM
- Volvo on certain heavy duty trucks equipped with meritor wabco pneumatic anitlock brake system (ABS) valve packages, the assembly bolts on these valve packages were not tightened correctly. 2001 Volvo VNL, VNM
- Volvo certain heavy duty class 8 trucks fail to comply with the requirements of federal motor vehicle safety standard no. 2001 Volvo VNL, VNM