Chrysler 200 recalls
- Chrysler are being recalled to address a defect that could prevent the cruise control system from disengaging. 2014–2018 Chrysler 200, 300, Pacifica +12 more
- Chrysler component within the occupant restraint controller (ORC) may fail and prevent the active headrests from deploying in the event of a rear-end crash. 2011–2012 Chrysler 200, Avenger, Liberty
- Chrysler occupant Restraint Control (OCR) module may short circuit, preventing the frontal air bags, seat belt pretensioners, and side air bags from deploying in the event of a crash. 2010–2011 Chrysler 200, Sebring, Avenger +3 more
- Chrysler multiple chassis fastener joints may not have been tightened to the proper torque specification. 2016 Chrysler 200
- Chrysler transmission sensor clusters may have insufficient crimps in the transmission wire harness, and as a result, the transmission may unexpectedly shift to neutral. 2014–2016 Chrysler 200, 500X, Cherokee +2 more
- Chrysler during service work, the affected vehicles may have had either the Occupant Classification Module (OCM) or the Seat Cushion Foam (SCF) of the front passenger seat replaced instead of the both pieces together, which make up a complete calibrated set. 2015 Chrysler 200
- Chrysler affected vehicles may have a Power Distribution Center (PDC) electrical connector that may cause intermittent power failures to certain electrical components. 2015 Chrysler 200
- Chrysler affected vehicles are equipped with radios that have software vulnerabilities that can allow third-party access to certain networked vehicle control systems. 2013–2015 Chrysler 200, 300, Challenger +10 more
- Chrysler automatic transmission parking pawl may become contaminated or the park rod may become dislodged or broken. 2015 Chrysler 200
- Chrysler affected vehicles may have been built with a driver side door wiring harness of an insufficient wire gauge, resulting in excessive heat which may melt the wiring insulation. 2015 Chrysler 200
- Chrysler due to an insufficient weld, the rear shocks may detach from the vehicle at one end and possibly damage other chassis components, the tire or result in reduced braking. 2014–2015 Chrysler 200, Cherokee, 1500
- Chrysler due to abrasive debris in the balance shaft bearings, these engines may have a loss of engine oil pressure, possibly resulting in an engine stall or engine failure. 2013–2014 Chrysler 200, Avenger, Compass +1 more
- Chrysler electrical over-stress of a resistor in the occupant restraint control module may lead to the non-deployment of the active head restraints during a rear impact collision. 2011 Chrysler 200, Sebring, Avenger +2 more
- Chrysler may have a gas tank that has a broken control valve in the fuel tank assembly. 2013 Chrysler 200, Avenger
- Chrysler these engines may experience connecting rod bearing failure due to debris inside the engine block. 2012 Chrysler 200, Town and Country, Charger +4 more
- Chrysler some of these vehicles may have been built with a missing or incorrectly installed steering column pivot rivet. 2011 Chrysler 200, Town and Country, Avenger +8 more