Can-Am recalls
Models
- Can-Am instrument cluster may reset, freeze, or go blank. 2024–2025 Can-Am Canyon, Origin, Pulse +2 more
- Can-Am fatigue failure of the front brake caliper support may occur and result in inoperative front brakes. 2025 Can-Am Origin
- Can-Am on these motorcycles, the drive belt lower idler support will fail and possibly cause a belt failure. 2025 Can-Am Canyon
- Can-Am breather valve may not seal properly and allow moisture or water to enter the high voltage battery. 2025 Can-Am Origin, Pulse
- Can-Am engine output shaft may fatigue and break, resulting in a loss of drive power. 2017 Can-Am Spyder F3, Spyder RT
- Can-Am rearview mirror lens may dislodge from the housing. 2023 Can-Am Spyder F3
- Can-Am impeller may swell, causing the high-pressure fuel pump to fail. 2019 Can-Am Ryker
- Can-Am brake lights may stay illuminated even if the brake pedal is not pressed. 2020–2022 Can-Am Ryker, Spyder RT
- Can-Am rearview mirror lens may detach from the housing. 2022 Can-Am Spyder, Spyder F3
- Can-Am position light and flasher electrical harnesses in the front fenders may loosen and rub on the tire, leading to a short circuit and resulting in an engine stall while driving. 2019 Can-Am Ryker
- Can-Am handlebar stem bolt may break unexpectedly due to insufficient thread length. 2022 Can-Am Ryker DO NOT DRIVE
- Can-Am front sprocket may be defective and prematurely wear, resulting in a loss of drive power. 2015 Can-Am Spyder F3, Spyder RT
- Can-Am front wheels may have been improperly installed, possibly resulting in their separation from the motorcycle. 2020 Can-Am Ryker
- Can-Am during emergency braking situations, the support which holds the brake mechanism could break, causing a total loss of braking ability. 2020 Can-Am Spyder RT
- Can-Am wheel nuts may crack, causing the wheels to loosen. 2019 Can-Am Ryker
- Can-Am due to a manufacturing error within the headlight assembly, the headlight may shine too high when on the low beam setting. 2017 Can-Am Spyder RT
- Can-Am bombardier Recreational Products Inc. 2013 Can-Am Spyder RT
- Can-Am tandem brake master cylinder manifold inlet may melt allowing the brake fluid to leak out. 2013 Can-Am Spyder, Spyder RT
- Can-Am fuel vapors may exit the fuel vapor canister vent hose in the enclosed engine compartment. 2008 Can-Am Spyder
- Can-Am fuel cap may not fit onto the fuel tank filler neck, preventing it from sealing properly. 2008–2010 Can-Am Spyder, Spyder RT
- Can-Am pin securing the brake pedal connecting rod could disengage and fall off. 2010 Can-Am Spyder RT
- Can-Am while down shifting it may be possible to inadvertently engage reverse without depressing the reverse button due to a defective reverse actuator cable. 2011 Can-Am Spyder RT
- Can-Am when bringing a vehicle equipped with the se5 SEMI-AUTOMATIC transmission to a full stop, the clutch may remain engaged stalling the engine. 2010 Can-Am Spyder, Spyder RT